UC知道英翻汉，固定名字可以不用翻译
来源：百度知道 编辑：UC知道 时间：2024/05/12 11:29:02
This is the space into which each jawneeds to fit in order to gain access to a ball. For a 300um ball and 500umpitch, the inter-ball distance is 500-300=200um. When I drew up the this jaw, Iallowed the jaw width to be 170-190um (see drawing attached). The actualminimum is always smaller than this because the ball will always fit slightlyinto the base of the cavity (see drawing).
The drawing shows two models of ballarray, one with 200um ball gap and the other with 170um ball gap. So in theory,the jaws should fit, but there isn’t much room to play with, so the jawsmust be accurately positioned and the ‘open’ jaw distance accuratelyset, to with 20um or better. I know that the set-up for the HS jaws is morecomplex and takes more practice and so this is probably the reason. Also thenormal jaw had a jaw width between 161-166um, this being due to the fact thatit was a custom design, with shallower cavities to allow a smaller jaw width.
The DD6372-2GJAW-300/500 are made f
The drawing shows two models of ballarray, one with 200um ball gap and the other with 170um ball gap. So in theory,the jaws should fit, but there isn’t much room to play with, so the jawsmust be accurately positioned and the ‘open’ jaw distance accuratelyset, to with 20um or better. I know that the set-up for the HS jaws is morecomplex and takes more practice and so this is probably the reason. Also thenormal jaw had a jaw width between 161-166um, this being due to the fact thatit was a custom design, with shallower cavities to allow a smaller jaw width.
The DD6372-2GJAW-300/500 are made f
这是空间变成每个jawneeds ，以适应以便获得一个球。为300um球和500umpitch ，跨球的距离是500-300 = 200um 。当我制定了这下巴， iallowed颌骨的宽度要170 - 190um （见制图附后） 。该actualminimum始终是小于这是因为球将永远适合slightlyinto的基础上腔（见制图） 。
绘图显示，两种型号的ballarray ，与200um一球的差距，和其他与170um球的差距。因此从理论上来讲，颌骨应适合，但已没有多少空间发挥，因此， jawsmust准确定位和'开启'颚距离accuratelyset ，与20um或更好。我知道的设立为房协颌骨是morecomplex ，并采取更多的实践，所以这可能是原因。也thenormal赵少康了下巴的宽度之间的161 - 166um ，这是由于事实上thatit是一个定制设计，与浅腔，让规模较小的下颚宽度。
该dd6372-2gjaw-300/500是由astandard 300um一套颌骨，因此只有外腔是可以改变的，它isalready接近最小尺寸。有可能是sufficientmaterial ，以减少颌骨的宽度，以170um与更严格的公差范围内， say165 - 175um ，这应使路线相当容易。如果有更多spacebetween球是需要的（较小的下颚宽度） ，那么我将不得不designedanother一套专门颌骨，与稍浅腔，让thejaw宽度有所减少。