UC知道有没有英文高手帮忙翻译3下！
来源：百度知道 编辑：UC知道 时间：2024/06/12 05:42:31
. Experimental results
Tool wear tests were conducted on a lathe, in the absence of coolant. The wear growth patterns were observed on uncoated carbide tool inserts (grade VC 5), while turning hot rolled steel. The workpiece was turned for 15 min before the lathe was stopped. Then the insert was positioned under the vision system and the flank wear and cutting-edge wear images were recorded and stored in the computer. This procedure was repeated for every 10 min of cutting on the lathe until a total of seven cuts were performed using the same insert. The following parameters were estimated: maximum wear land width, wear land area, wear land perimeter, and the slope of tangent in particular points, to get the profile deepness. For analyzing those parameters, analyzed, are shown in Fig. 8, which presents an extreme condition.Among others it is possible to project a line on surface, andhen find out deepnes in arbitrary points, and
Tool wear tests were conducted on a lathe, in the absence of coolant. The wear growth patterns were observed on uncoated carbide tool inserts (grade VC 5), while turning hot rolled steel. The workpiece was turned for 15 min before the lathe was stopped. Then the insert was positioned under the vision system and the flank wear and cutting-edge wear images were recorded and stored in the computer. This procedure was repeated for every 10 min of cutting on the lathe until a total of seven cuts were performed using the same insert. The following parameters were estimated: maximum wear land width, wear land area, wear land perimeter, and the slope of tangent in particular points, to get the profile deepness. For analyzing those parameters, analyzed, are shown in Fig. 8, which presents an extreme condition.Among others it is possible to project a line on surface, andhen find out deepnes in arbitrary points, and
参考
实验结果
刀具磨损试验进行了车床，在没有冷却剂。磨损的增长模式，观察对未硬质合金刀具的插入（一级的VC 5 ） ，而至于热轧钢材。工件被转15分钟前，车床被截停。然后插入的位置是根据视觉系统和后刀面磨损和尖端磨损的图像记录，并存储在计算机。这一程序是重复，每10分钟刈割对车床，直到一共有七个削减演出使用相同的插入。以下参数估计：最大磨损宽度土地，土地面积磨损，磨损的土地周边，以及边坡的切线，特别是点，以获得个人资料的深度。分析这些参数，分析，显示在图。八，其中介绍了一个极端的condition.among他人是有可能的项目一条线的表面， andhen找出deepnes在任意点，也找出
曲率和切线的价值。
在图。九，这是清楚地看到如何的形状，切和
曲率预计激光束是在不断变化的依赖表面的斜坡，而炮塔头的一个工具插入istravelling在一个非常缓慢的进给速度。磨损图像
记录在不同阶段的切削过程。该工具的路径和进给速度是程序内的NC程序对车床森精机153晚上八。所有的刀具磨损参数的测量，并获得用形象的工具软件，没有必要使用工具显微镜。
该repeatibility的刀具磨损参数的计算从5测量刀具磨损的个人资料下，得到同样的光照条件。可以预计的