UC知道英语翻译，高手接招！！
来源：百度知道 编辑：UC知道 时间：2024/06/06 16:34:33
1.With the test fixture(see figure 2)attached to the tendile test apparatus,insert the stripped end of the center conductor through the appropriate hole in the test plate.
2.Secure the center conductor in the jaws of the tendile tester.
3.Set the load indicator to zero.
4.Start the tensile test apparatus traveling member at a rate of 2 inches per minute.
5.Allow it to continue until breaking the center conductor bond.(This is evidenced by no further increase in load.)
2.Secure the center conductor in the jaws of the tendile tester.
3.Set the load indicator to zero.
4.Start the tensile test apparatus traveling member at a rate of 2 inches per minute.
5.Allow it to continue until breaking the center conductor bond.(This is evidenced by no further increase in load.)
1.将附属在拉力测试仪器上的测试设备（参考：图2），通过测试板上的指定圆孔插入导体中心的末端；
2.用测试设备的钳口将导体中心固定；
3.将仪器指针设置为0；
4.开动测试仪器，按照每分钟2英寸的速率移动；
5.直到它冲破导体连接的中心部分，才能停下。
（通过不断增加负荷来得出最终数据）
ok?
应该差不多吧？
没有悬赏啊？