UC知道电脑开机没有反应红灯绿灯一直亮
来源：百度知道 编辑：UC知道 时间：2024/06/25 16:13:48
电脑开机没有反应红灯绿灯一直亮,按重启光盘灯闪了几下也没反应,按关机键3秒以上才关得掉,关机一段时间又正常 一直这样;即便正常启动了安装XP的时候还没到按回车安装就黑屏只亮绿灯没反应或一到复制文件那一步才8%或更少就老提示无法读取重试,换成刚刻光盘也不行,按着按着重试就蓝屏出现了一堆E文:problem has been detected and windows has been shut down to prevent damage to your computer.
DAGE_FAULT_IN_NONPAGED_AREA
If this is the first time you've seen this stop error screen,restart your computer.If this screen appears again,follow these steps:
Check to make sure any newhardware or software is properly installed.Ifthis is a new installation,ask your hardware or software manufaoturer for any windows updatesyoumight need.
Ifprblems contiue,disable or remowe any newy installed hardware or software,Disable BIOS memory options such as caching or shadowing.If you need to use safe mode to remove ordisable components,restart your computer,press F8 to select Aduaneed startup optidns,and then selcct Safe Mode. 或一堆0*00000000
电脑是刚刚加了硬盘和内存我以为是硬件有问题,换回以前的配置也一样出现上述问题,又把所有硬件(原配置基础上)拔了擦干净重插
DAGE_FAULT_IN_NONPAGED_AREA
If this is the first time you've seen this stop error screen,restart your computer.If this screen appears again,follow these steps:
Check to make sure any newhardware or software is properly installed.Ifthis is a new installation,ask your hardware or software manufaoturer for any windows updatesyoumight need.
Ifprblems contiue,disable or remowe any newy installed hardware or software,Disable BIOS memory options such as caching or shadowing.If you need to use safe mode to remove ordisable components,restart your computer,press F8 to select Aduaneed startup optidns,and then selcct Safe Mode. 或一堆0*00000000
电脑是刚刚加了硬盘和内存我以为是硬件有问题,换回以前的配置也一样出现上述问题,又把所有硬件(原配置基础上)拔了擦干净重插
一般这种情况都是内存金手指氧化或者接触不良造成的。遇到这种情况：
1，先拔掉电脑电源线，按下机箱上的开关键5-6下。释放主板的残余电荷。
2，然后打开机箱侧板，插拔更换一下内存的插槽。
3，扣掉主板上的CMOS电池，过1分钟之后在安上。
