UC知道中译英 急!!! A面 RRD通道锁安装示意图
来源：百度知道 编辑：UC知道 时间：2024/06/12 05:44:01
将说明书B面边缘线对齐门边缘，标定锁头及锁身螺丝孔的位置开孔，开孔时用小钻花垂直钻直钻穿门上所标的圆心，然后用Φ35开孔器两边对挖。
门边缘
门里面
套上锁头，安装锁头，上紧锁头固定螺丝，开关片伸出门表面长为7MM
门外面
将锁头的开关片伸出锁身之开关孔，上紧头尾之螺丝，将锁身固定，安装锁身前后锁盖去处。
盖上前后锁盖，上紧固定螺丝即成。
单门锁扣装置情景
锁扣与门框边缘线对齐安装
注意：在安装单门时，B面定位图门边缘线与边框的距离应为30MM
B面
右边门
此处请附于门缘可定位开锁孔
上螺丝孔位
此处为圆心开孔Φ35MM
安装双门时距离17MM
门边缘线
说明：安装双开门时。将此图门边缘线折起，对齐门边缘即可定位开孔。
安装单开门时，门框与此圈门边缘线的距离为30MM。
A surface channel RRD lock installation diagram
Statement B side will line the edge of the edge of the door alignment, the demarcation of the first lock and locking screw holes are the location of the hole, drill a small hole used to spend Zhizuan vertical drilling through the door on the subject of the center, and then use the device on both sides of the opening Φ35 Digging.
The edge of the door
Inside the door
Locked up in the first set, the installation of the first lock, the first fixed-locking screw, chip out the door switch on the surface for a long 7MM
Outside the door
The switch will lock the first film are locked out of the hole switch, bear in the head and tail of the screw will be fixed lock body, to install locks are locked before and after the place to build.
Cover before and after the lock cover, screw on tight fixed mold.
Single-door locking device scenarios
And