UC知道cc2430翻译（24）
来源：百度知道 编辑：UC知道 时间：2024/05/21 05:37:09
14.2 Command strobes
The CPU uses a set of command strobes
to control operation of the radio in CC2430.
Command strobes may be viewed as
single byte instructions which each control
some function of the radio. These
command strobes must be used to enable
the frequency synthesizer, enable receive
mode, enable transmit mode and other
functions.
A total of nine command strobes are
defined for the radio and these can be
written individually to the radio or they can
be given in a sequence together with a set
of dedicated software instructions making
up a simple program. All command strobes
from the CPU to the radio pass through
the CSMA-CA/Command Strobe
Processor (CSP). Detailed description
about the CSP and how command strobes
are used is given in section 14.34 on page
186.
14.3 RF Registers
The operation of the radio is configured
through a set of RF registers. These RF<
The CPU uses a set of command strobes
to control operation of the radio in CC2430.
Command strobes may be viewed as
single byte instructions which each control
some function of the radio. These
command strobes must be used to enable
the frequency synthesizer, enable receive
mode, enable transmit mode and other
functions.
A total of nine command strobes are
defined for the radio and these can be
written individually to the radio or they can
be given in a sequence together with a set
of dedicated software instructions making
up a simple program. All command strobes
from the CPU to the radio pass through
the CSMA-CA/Command Strobe
Processor (CSP). Detailed description
about the CSP and how command strobes
are used is given in section 14.34 on page
186.
14.3 RF Registers
The operation of the radio is configured
through a set of RF registers. These RF<
2月14日命令频闪灯中央处理器采用了一套命令频闪灯控制操作电台CC2430 。 命令频闪灯可以被看作单字节指令，每个控制一些职能电台。这些命令频闪灯必须使用，使频率合成器，能够接收模式，使传输模式及其他职能。 总共有9命令频闪灯定义的无线电台和这些可书面个别电台，也可以考虑在一个序列连同一套专门的软件指示决策一个简单的程序。所有命令频闪灯从CPU的电台通过塔尔博特的CSMA-CA/Command 处理器程序（ CSP ） 。详细说明关于CSP和如何指挥频闪灯使用一节给出了14.34的一页 186 。 14.3射频寄存器运行的无线电配置通过一套射频登记。这些射频寄存器映射到XDATA内存空间所显示的图13第37页。 射频寄存器也提供地位信息从收音机。 射频寄存器控制/状态位提到酌情在以下各节的节则14.35 页198给出了详尽描述，所有的RF 登记册。
我晕，建议有看不懂的地方可以问，没必要整段翻译吧。
到这里找吧！