UC知道每次电脑开机都出现f1 f2选项
来源：百度知道 编辑：UC知道 时间：2024/06/24 06:52:06
具体提示为：Attention :Unsupported video configuration Detected
Action is required
This computer has an add-in graphics card,but the monitor cable is plugged into the intergrated video connection.
To attoch the monttor cable to the add-in graghics card
1.shut down the computer
2.plug the montor cable into the add-in graphics card connection this may require a video adgrer or video adpter cable
3.Turn on the computer
This messege should not qppeer after completing these steps
For more information or help,please refer to the system documentation
Press F1 to contine,F2to enter setup(电脑为dell台式机，系统为xp）
Action is required
This computer has an add-in graphics card,but the monitor cable is plugged into the intergrated video connection.
To attoch the monttor cable to the add-in graghics card
1.shut down the computer
2.plug the montor cable into the add-in graphics card connection this may require a video adgrer or video adpter cable
3.Turn on the computer
This messege should not qppeer after completing these steps
For more information or help,please refer to the system documentation
Press F1 to contine,F2to enter setup(电脑为dell台式机，系统为xp）
注意:即视频配置
行动是必要的
这台计算机有一个嵌入程序的图形卡,但监测电缆插电视频连接。
对attoch创建的monttor电缆graghics卡
1.shut下来的计算机
2.plug montor电缆的连接到插件的图形卡本可能需要一个视频adgrer或视频adpter电缆
3。打开电脑
这种“哔”声不应该qppeer完成后,这些步骤
为更多的信息和帮助,请参阅系统文档
按F1继续,F2to进入设置
这是帮你翻译的.进BIOS还原下设置就好了
电脑有两个显卡
你是不是接在哪个集成显卡上呀!
这个现象是正常的.
有两种办法:
1.把独立显卡拔掉
2.把显示器接到独立显卡上
独立显卡的接线和集成的可能不一样
应该是主板BIOS设置错误。
建议你取下主板的电池（纽扣电池）。静待5分钟左右后，重新装上。
F1是把软驱打开了吧.进BIOS里关闭软驱就行了.