KEIL不能编译的程序

我有一个程序，用KEIL编译后，显示对象不能被编译，自己没有找到原因，所以请前辈们帮帮忙，谢谢。程序如下，

#include <AT89X52.H>
#include <intrins.h>
#define uint unsigned int
#define uchar unsigned char
#define BLKN 2 /*列存贮器数8*8行数*/
sbit E1 =P3^4; //E1为0开列(col)输出显示允许控制信号端口
sbit ST_CP =P3^2; //ST_CP 上升沿--移位寄存器的数据进入数据存储寄存器 输出锁存器的时钟信号端口
sbit MR =P3^3;//MR 为0将移位寄存器的数据清0
sbit key1 =P0^0;
sbit key2 =P0^1;
sbit soundring=P0^7;
uchar t1;
uint key,spd;
void delay(unsigned int);
uchar data dispram[32];
uchar code table[]={ 0xC0,0xF9,0xA4,0xB0,0x99,0x92,0x82,0xF8, 0x80,0x90,0x88,0x83,0xC6,0xA1,0x86,0x8E,0xFF};
uchar code donghua[][1]={
{0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0x7F,

};
void delay(uint dt);

void main( )
{
uchar num,cur,tmp,nums=sizeof(donghua)/32;
SCON = 0x01;
TMOD = 0x01;
TH1=(65536-50

帮你改了下！ 自己在改改吧！

#include <AT89X52.H>
#include <intrins.h>
#define uint unsigned int
#define uchar unsigned char
#define BLKN 2 /*列存贮器数8*8行数*/
sbit E1 =P3^4; //E1为0开列(col)输出显示允许控制信号端口
sbit ST_CP =P3^2; //ST_CP 上升沿--移位寄存器的数据进入数据存储寄存器 输出锁存器的时钟信号端口
sbit MR =P3^3;//MR 为0将移位寄存器的数据清0
sbit key1 =P0^0;
sbit key2 =P0^1;
sbit soundring=P0^7;
uchar songndring=0;//add by mrli
uchar Soundring=0;//add by mrli

uchar t1;
uint key,spd;
void delay(unsigned int);
uchar data dispram[32];
uchar code table[]={ 0xC0,0xF9,0xA4,0xB0,0x99,0x92,0x82,0xF8, 0x80,0x90,0x88,0x83,0xC6,0xA1,0x86,0x8E,0xFF};
uchar code donghua[][1]={0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0xFF,0x7F };//change by mrli

void delay(uint dt);

void main( )
{
uchar num,cur,tmp,nums=sizeof(donghua)/32;
SCON = 0x01;