UC知道紧急求助！！！在线等答复！！！
来源：百度知道 编辑：UC知道 时间：2024/05/22 10:56:00
前段时间开始出现关机蓝屏现象 是我在加了内存开始
他们说是我内存可能松了什么的
我弄了好多次还是这样
最近几天厉害了 动不动就蓝屏
急啊 我把内存拔了试也蓝屏 就估计不是内存问题了
蓝屏代码如下：
A problem has been detcted and windows has been shut down to prvent damage to your computer.
IRQL_NOT_LESS_OR_EQUAL
If this is first time ,you've seen this stop error scren,restart your computer,if this screen appears again, follow these steps:
Ckeck to ake sure any new hardware or software is properly installed.If this is a new installation,ask your hardware or software manufacturer for any windows updates you might need.
If problems continue,disable or remove any newly installed hardware or software,Disable BIOS memory options such as caching or shadowing.If you need to use safe Mode to remove or disable components,resrart your computer,press F8 to select Advanced Startup Options,and then selsct Safe Mode.
Technical information:
***SHOP:0x0000000A(0xE1E11B48,0x00000002,0x0000
他们说是我内存可能松了什么的
我弄了好多次还是这样
最近几天厉害了 动不动就蓝屏
急啊 我把内存拔了试也蓝屏 就估计不是内存问题了
蓝屏代码如下：
A problem has been detcted and windows has been shut down to prvent damage to your computer.
IRQL_NOT_LESS_OR_EQUAL
If this is first time ,you've seen this stop error scren,restart your computer,if this screen appears again, follow these steps:
Ckeck to ake sure any new hardware or software is properly installed.If this is a new installation,ask your hardware or software manufacturer for any windows updates you might need.
If problems continue,disable or remove any newly installed hardware or software,Disable BIOS memory options such as caching or shadowing.If you need to use safe Mode to remove or disable components,resrart your computer,press F8 to select Advanced Startup Options,and then selsct Safe Mode.
Technical information:
***SHOP:0x0000000A(0xE1E11B48,0x00000002,0x0000
首先需要重新做一下系统~如果问题依旧，需要去找一下所有的硬件的驱动，重新安装~如果还继续同样的状况~可以在BIOS里关掉CPU的CATCH~
问题应该就可以解决了~但是CPU的缓存如果关掉的话~是会影响很大一部分性能的~所以如果真的是这种情况~建议更换CPU~：）
打印机出错了吧？
irq：向并口分配端口地址，设置为auto，或者
进入bios后直接Load Optimal Settings即可，——载入最佳默认参数设置；提醒：（Y，Enter）可在绝大多数内存和硬件参数下工作，要求不高，但是，有可能关闭一些功能比如USB。
irq:pci显卡出差错，没有分配端口中断信号给它？
你所说的故障可能是由于采用了几种不同芯片的内存条，由于各内存条速度不同产生一个时间差导致的问题，可以在BIOS设置里面降低内存速度看能否解决。如果能进安全模式的话可以在安全模式下屏蔽或是禁用其中一根内存条，看能不能解决。
把所有插头拔了重插一遍,OK?