UC知道谁能帮我翻译一下 这个 电子相关的 不要用软件翻译
来源：百度知道 编辑：UC知道 时间：2024/06/14 23:05:19
AD7476/AD7477/AD7478 to TMS320C5x/C54x Interface
The serial interface on the TMS320C5x uses a continuous serial
clock and frame synchronization signals to synchronize the data
transfer operations with peripheral devices like the AD7476/
AD7477/AD7478. The CS input allows easy interfacing between
the TMS320C5x/C54x and the AD7476/AD7477/AD7478 without
any glue logic required. The serial port of the TMS320C5x/
C54x is set up to operate in burst mode with internal CLKX (Tx
serial clock) and FSX (Tx frame sync). The serial port control
register (SPC) must have the following setup: FO = 0, FSM =
1, MCM = 1 and TXM = 1. The format bit, FO, may be set to 1
to set the word length to eight bits, in order to implement
the power-down mode on the AD7476/AD7477/AD7478. The
connection diagram is shown in Figure 24. It should be noted that
for signal processing applications, it is imperative that the frame
synchronization sign
The serial interface on the TMS320C5x uses a continuous serial
clock and frame synchronization signals to synchronize the data
transfer operations with peripheral devices like the AD7476/
AD7477/AD7478. The CS input allows easy interfacing between
the TMS320C5x/C54x and the AD7476/AD7477/AD7478 without
any glue logic required. The serial port of the TMS320C5x/
C54x is set up to operate in burst mode with internal CLKX (Tx
serial clock) and FSX (Tx frame sync). The serial port control
register (SPC) must have the following setup: FO = 0, FSM =
1, MCM = 1 and TXM = 1. The format bit, FO, may be set to 1
to set the word length to eight bits, in order to implement
the power-down mode on the AD7476/AD7477/AD7478. The
connection diagram is shown in Figure 24. It should be noted that
for signal processing applications, it is imperative that the frame
synchronization sign
AD7476/AD7477/AD7478 对TMS320C5x/C54x 接口 串行接口在TMS320C5x 使用连续的连续 时钟和框架同步信号同步数据 调用操作以外围设备喜欢AD7476/ AD7477/AD7478 。CS 输入允许容易连接之间 TMS320C5x/C54x 和AD7476/AD7477/AD7478 无 任何胶浆逻辑要求。TMS320C5x/ 的连续端口 C54x 被设定经营在脉冲串式下与内部CLKX (Tx 连续时钟) 和FSX (Tx 框架sync) 。连续端口控制 记数器(SPC) 必须有以下设定: FO = 0, FSM = 1, MCM = 1 和TXM = 1 。格式位, FO, 也许被设置到1 设置词长对八位, 为了实施 力量下来方式在AD7476/AD7477/AD7478 。 连接图被显示在表24 。值得注意的是, 为信号处理应用, 它是必要的框架 同步信号从TMS320C5x/C54x 将提供 等距离采样。