哪位高手帮我翻译一下英文吧~我水平有限!!谢谢啊!!感激......

来源：百度知道 编辑：UC知道 时间：2024/06/10 05:06:03
One hundred milliliter of sample was introduced into a 2 50-ml beaker at room temperature(25C).The pH of the sample was adjusted by adding sulfuric acid.20 g/L of FeSO4•7 H20 and 3% H202 were then added to the sample and the mixture was stirred and left at a standstill for 1h .After sedimentation,the supenratant was withdrawn for COD and color analysis.
Experiments (not presented here)conducted on the pharmaceutical wastewater for the selection and optimization of coagulants (A12(SO4)3 polyaluminum chloride (PAC), FeCl3 and polyferrie sulfate (PFS)) Showed that A12(SO4)3
Performed well by f ar.Thus, the coagulation process was performed using sulfate aluminum (A12(SO4)3) as coagulant, at the pre-determined optimal concentration and pH value of 800 mg/L and 5 ,re spectively.
After the Fenton's reaction, the coagulant (A12(SO4)3) was added to the sample with rapid mixing at 300 r/min for 0.5 min, followed by slow mixing at 50 r/min for 10 min. After 30 m

100毫升样品被引入了250毫升的烧杯,在室温下(25c). pH的样品 调整了添加硫酸acid.20g/l硫酸亚铁•7h20和3%h202然后再加标本及 混合搅拌和左处于停顿8.91%. 经过沉淀,supenratant被撤回,COD和色度分析.

实验(这里没有介绍)进行的制药工业废水的优选混凝剂(a12(so4)3聚合氯化铝(PAC) FeCl3和polyferrie硫酸(加油站))显示a12(SO4)3的表现不错的Far.thus, 凝血过程是用硫酸铝(A12号(so4)3)作为混凝剂, 在预先确定的最佳浓度和pH值为800毫克/升和5,再spectively.

之后芬顿反应 混凝剂(a12(so4)3)增加了样品的快速混合,在300r/分钟,0.5分钟, 其次是缓慢的搅拌在50r/分钟,10分钟. 30分钟后,沉淀,上清撤回COD和颜色分析

1000毫升样品被引入某一烧杯中含100.0克hexahydrothymol

作为内部标准. 10%氢氧化钠用来调整pH值(pH值大于1). 基本内容的样本,然后抽取3倍 50毫升
dichloromethane.The 酸碱度残余的酒w 依照对酸碱度o f 2 u 被调整唱6 mol/L H 2SO4, 酸性内容被提取如上所述的d 。二提取的酒被带来了和被烘干了为大约24 h 被无水sulfate 钠, 和最后被蒸发了对1.0ml 在K-D (Kudema 丹麦蒸发器) 。残余的酒的1.0?1 被撤出了为GC-MS 分析。

finnigan张锦堂被用来作为分析工具,以气相色谱-质谱法(GC-MS)分析, 与db-5石英毛细管柱(30m×0.25毫米,0.25米). 柱温programmed从50℃(2分钟)到300℃(10min),以升温速度10)c /分钟,输送天然气他是1.0毫升/分钟,分裂比例为20:1. 源温度在200`c,电离能量70ev(电子伏). 解释由此图谱及质谱分析用的NIST(国家标准和技术研究所)图书馆.

100毫升样品被引入了250毫升的烧杯,在室温下(25c). pH的样品 调整了添加硫酸acid.20g/l硫酸亚铁? 7h20和3%h