高分求一段建筑类英语翻译

来源：百度知道 编辑：UC知道 时间：2024/05/16 17:25:53
of low strain rate under strain-controlled condition, an overshoot appears at the point and an undershoot at the point . On the other hand, in the case of high strain rate, both overshoot and undershoot do not appear. In the case oflow strain rate, the interface between the M-phase and the parent phase moves under constant stresses which are expressed by stress plateaus following the points and . At the points and , an excessive energy is necessaryto create a nucleus of the induced phase compared with the movement of the interface, and therefore an overshoot and an undershoot appear. The MT is exothermic and the reverse transformation endothermic. In the case of low strain rate, heat generated by SIMT in the interface is radiated and therefore temperature does not increase. On the contrary, in the case of high strain rate, because the interface at the temperature increased by SIMT moves, temperature of the materialincreases during the MT and therefore the MT stress increases. I

低应变速率下应变控制条件下,一个看似过头的点和一个欠位点. 在另一方面,在案件的高应变率,无论是过冲和欠不相符合. 在案件综合利用应变率, 接口M-相和母相动作下不断强调所表达的应力高原以下 论点. 在点, 过高的能源是必要建立一个核心的诱导期相比变动的界面, 因此过头了,并欠出现. 贺兰山是放热和逆转变吸热. 在低应变率, 热难当simt在界面辐射,所以气温不增加. 在相反的,在如此高的应变率, 因为界面的温度上升simt动作 温度的materialincreases在金刚山,因此MT在应力增大. 在发生逆向转变,较高的应变速率的增大,温度降低, 造成下降的转型压力. 基于thesereasons ,无论是过冲和欠不出庭的情况下,高应变率. 从图. 3款( b ) ,两个超和欠不出现应力控制条件下. 这是由于在应力控制条件下,压力增加,在加载过程中,跌幅在卸载过程. 在thiscase , MT和反向转变开始,分别在同一讲所举行的出发点和供 低应变速率. 因为数额变化强调的是小,在改造区内thedeformation (应变)率变得很高, 由此在同一变形行为,在高应变率.

of low strain rate under strain-controlled condition, an overshoot appears at the point and an undershoot at the point . On the other hand, in the case of high strain rate, both overshoot and undershoot do not appear. In the case oflow strain rate, the interface between the M-phase and the parent phase moves under constant stresses which are expressed by stress plateaus following the points and . At the points and , an excessive energy is necessaryto create a nucleus of the induced phase com