电焊机翻译10

来源：百度知道 编辑：UC知道 时间：2024/05/05 14:12:50
谢绝机器翻译！
H:故障检修WSE-200
故障现象 解决措施
风机不转，无焊接输出 1. 电源开关坏。
2. 确认输入电缆线所接的电网是否有电。
3. 确认输入电缆线是否有断路处
风机不转或几下就停下来，无焊接输出 1． 可能输入错接在380V电源上，造成过压保护电路起动，改接在220V电源上，重新开机即可。
2． 220V电力不稳（输入线细过长）或输入线搭接在电网上，造成过压保护电路起动，增加电网输入线的线径或紧固输入线结点，这种现象关机2-3分钟后重新开机可恢复正常。
3． 短时间内连续开闭电源开关，造成过压保护电路起动，关机等待2-3分钟后重新开机即可。
4． 开关到电源板间的导线松脱，重新紧固
5． 电源板上的主回路24V继电器未吸合或损坏，查24V电源和继电器。
谢绝机器翻译！

H. Trouble shooting for model WSE-200

Problems
Ventilation fan not running, no welding current output

Causes and Solutions
1.Power switch not functioning
2.Ensure the input cable is connected to a live power source.
3.Ensure there is no break of circuit in the input cable

Problems
Ventilation fan not running or stops after a few turns,
no welding current output

Causes and Solutions
1.Input cable may be wrongly connected to 380V power supply, triggering the overload protection. Reconnect to a 220V power supply and restart.
2.220v power supply unstable (input cable too small or too long), or the input cable connection triggers the overload protection. Increase the diameter of the cable and tighten the connection, switch off the machine and wait for 2 or 3 minutes before restarting to continue welding.
3.Power switch turned on and off continuously in a short span of time, resulting in the activat