UC知道重装系统后无法进入系统了//
来源：百度知道 编辑：UC知道 时间：2024/05/24 13:03:21
重装系统后无法进入系统了..
出现进入画面后几秒蓝屏..而且出现以下代码..
A problem has been detected and windows has been shut down to prevent damage to your computer.
The video driver failed to initialize
If this is the first time you've seen this stop error screen, restart your computer, If this screen appears again ,follow these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software is properly installed.
If this is a new installation, ask your hardware or software manllfacturer
For any windows updates you might need.
If problems continlle, disable or remove any newly installed hardware or software . Disable Bios memory options such as caching or shadowing. If you need to use safe Mode to remove or disable components, restart your computer, press F8 to select Advanced startup options, and then select safe Mode.
Technical information:
***STOP:OXOOOOOOB4:(0X83691B80,0
出现进入画面后几秒蓝屏..而且出现以下代码..
A problem has been detected and windows has been shut down to prevent damage to your computer.
The video driver failed to initialize
If this is the first time you've seen this stop error screen, restart your computer, If this screen appears again ,follow these steps:
Check to make sure any new hardware or software is properly installed.
If this is a new installation, ask your hardware or software is properly installed.
If this is a new installation, ask your hardware or software manllfacturer
For any windows updates you might need.
If problems continlle, disable or remove any newly installed hardware or software . Disable Bios memory options such as caching or shadowing. If you need to use safe Mode to remove or disable components, restart your computer, press F8 to select Advanced startup options, and then select safe Mode.
Technical information:
***STOP:OXOOOOOOB4:(0X83691B80,0
0x000000B4:VIDEO_DRIVER_INIT_FAILURE
错误分析:这个停止信息表示Windows因为不能启动显卡驱动, 从而无法进入图形界面. 通常是显卡的问题, 或者是存在与显卡的硬件冲突(比如:与并行或串行端口冲突).
解决方案:进入安全模式查看问题是否解决, 如果可以, 请升级最新的显卡驱动程序, 如果还不行, 则很可能是显卡与并行端口存在冲突, 需要在安全模式按下WIN+break组合键打开"系统属性", 在硬件-->设备管理器中找到并双击连接打印的LPT1端口的项, 在"资源"选项卡中取消"使用自动配置"的构选, 然后将"输入/输出范围"的"03BC"改为"0378".
连安全模式都进不去的话，再重装系统就可以解决了
按提示为显卡驱动出了问题。
你的系统盘是不是GHOST版的？还是纯安装系统碟？
解决的方法：进系统前按F8进安全模式去除显卡驱动试试了。
建议进安全模式,,, 把声卡卸载掉
然后再进系统看一下
这种情况很有可能是声卡驱动出错