UC知道电脑起不来机.
来源：百度知道 编辑：UC知道 时间：2024/06/18 14:59:14
在关机的时候突然死机.然后就按机POWER关机了.
在开就开不开了.出现A problom has been detected and windows has been shut down to prevent damage to your computer
DRIVER_LROL_NOT_LESS_OR_EQVAL
If this is the first time you've seen this stop error screen,restart your computer,If this screen appears again,follow these steps:
Check to make sure ang new hardware or software is properly installed.If this is a new installation,ash your hardware or software manufacturer for ang windows updates you might need.
If problems continue,disable or remove ang newly installed hardware of software.Disable BIOS memory options such as caching orshadowing.If you need to use Safe Mode to remove of disable components,restart your computer,preaa F8 to select Advanced Startup options,and then select Safe Mode.
Technical information:
***Stop:0x000000D1 <0xBEF25F08,0x00000002,0x00000000,0xFC436A2F>
机器的配置超低.在关机的时候反应太慢.然后就死机了.
在开就开不开了.出现A problom has been detected and windows has been shut down to prevent damage to your computer
DRIVER_LROL_NOT_LESS_OR_EQVAL
If this is the first time you've seen this stop error screen,restart your computer,If this screen appears again,follow these steps:
Check to make sure ang new hardware or software is properly installed.If this is a new installation,ash your hardware or software manufacturer for ang windows updates you might need.
If problems continue,disable or remove ang newly installed hardware of software.Disable BIOS memory options such as caching orshadowing.If you need to use Safe Mode to remove of disable components,restart your computer,preaa F8 to select Advanced Startup options,and then select Safe Mode.
Technical information:
***Stop:0x000000D1 <0xBEF25F08,0x00000002,0x00000000,0xFC436A2F>
机器的配置超低.在关机的时候反应太慢.然后就死机了.
先把内存重新插一下 要插好 如果还这样的话 那就重装吧 估计是系统的问题 重装后看还会不会这样
补充回答：呵呵 超低啊 那就没办法了 可能是电脑背不主给卡死了 但是我估计系统也有问题
最好先重装下系统,重装后还不行就把BIOS放下电，把内存清理下，再检查下，内存，硬盘，是否插紧。要是还不行，就把内存取下来开机看是否报警，要是不报警有可能就是主板上的电容烧爆了，换个电容就OK了
可以先用系统盘引导进入修复下,不行查看内存,或者在重装
先把内存重新插一下 要插好 如果还这样的话 那就重装
先查看硬件部分如CPU、内存、显卡都有没有插紧然后检查主板是不是有某个电容爆了（电容爆了就是电容上的铝制膜鼓起来了）然后如果都没有问题那你就从装一下系统