UC知道(1)帮忙把英文翻译成中文（机械专业的）
来源：百度知道 编辑：UC知道 时间：2024/06/07 08:05:02
Applying a Pressure Load
Here is another reason why we needed a cylindricalcoordinate system in the model (actually the mainone - since we couldn’t do the following withoutit). In the STRC MODEL menu select (on the waythrough this, note there is no option in the LOAD
TYPE menu for pressure, as there was whentreating solids in the previous lesson)
Loads > New > Edge/CurveSelect New and call the load set [pressure].In the
definition window, call the load [pres500]. Use the button under Curves and pick on the inside curve of the model. Middle click. The coordinate system is CS0. In the Distribution pull-down lists,select Force Per Unit Area, Uniform. Finally,enter an R component of 500. Preview the load,then select OK.
Figure 20 Setting up a pressure load
Applying a Temperature Load
For something a little different, we will apply a temperature load to the model. We will apply a
uniform (“global”) temperatu
Applying a Pressure Load
压力负荷的运用
Here is another reason why we needed a cylindricalcoordinate system in the model (actually the mainone - since we couldn’t do the following withoutit).
我们为什么要在模型中使用一个圆柱体，还有另一个原因（事实上，如果没有这个主体，我们无法进行下一步。）
In the STRC MODEL menu select (on the waythrough this, note there is no option in the LOAD
TYPE menu for pressure, as there was whentreating solids in the previous lesson)
Loads > New > Edge/CurveSelect New and call the load set [pressure].
在STRC MODEL菜单中选择（操作这一步时候，确保“负荷类型”的选项中没有选择任何命令，因为要保证在先前的步骤中没有其他固体图形存在，从而造成影响）加载>新建>边缘/弧线选择 新建并使用【压力】加载设置。
In the
definition window, call the load [pres500]. Use the button under Curves and pick on the inside curve of the model. Middle click.The coordinate system is CS0.
在定义窗口中，设置加载量为【500个单位压力】。使用弧线下面的按钮并点击模型弧线的内部。用鼠标中键点击。协调系统为CS0.
In the Distribution pull-down lists,select Force Per Unit Area, Uniform. Finally,enter an R component of 500. Previe