UC知道合众达仿真器和CCS连接问题
来源：百度知道 编辑：UC知道 时间：2024/05/30 10:41:59
目标板和Seed仿真器连接时出现如下错误，我的目标板Vcc=5V,Seed的Demo板是3.3V。可能是控制板问题，Seed的Demo 板工作正常。请问我的控制板上可能哪些地方有问题？
错误提示：
Failed Software Reset:
Error 0x00000024/-1031
Error during: Register, Execution,
Device driver: Problem with the Emulation Controller.
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
Sequence ID: 17
Error Code: -1031
Error Class: 0x00000024
错误提示：
Failed Software Reset:
Error 0x00000024/-1031
Error during: Register, Execution,
Device driver: Problem with the Emulation Controller.
It is recommended to RESET EMULATOR. This will disconnect each
target from the emulator. The targets should then be power cycled
or hard reset followed by an emureset and reconnect to each target.
Sequence ID: 17
Error Code: -1031
Error Class: 0x00000024
大概翻译：
软件复位失败：
错误0x00000024/-1031
错误发生在期间： 寄存器（或记数器），执行器，
设备驱动程序： 仿效控制器的问题。
推荐重新设置仿真器。 这从仿真器将分开每个目标。
目标应该然后是力量循环的或重新设置仿真器跟随的硬重起和再联接到每个目标
建议：复位仿真器（RESET EMULATOR）.