UC知道激光雕刻切割机的操作说明，翻译
来源：百度知道 编辑：UC知道 时间：2024/06/04 07:24:50
要正确连接激光管的正负极。首先要正确分清激光管的正负极，输出端为负极（—），另一端为正极（+）。连接电极引线如果要焊接，请注意不要温度过高，时间过长，否则容易留下漏气隐患。长时间工作后，高压电极正极（+）附近会有粉尘堆积，会影响使用效果。我们建议：用绝缘硅胶对电极周围进行灌封。
避免激光管的输出窗口被污染。在调试光及工作中，不要让被加工件产生的烟雾溅射到输出腔镜外表面，防止被污染使激光功率下降。如果已经有污染现象，可用酒精棉同一个方向转动轻拭窗口外表面。
调试过程中，可以调整激光管的机械支撑点和小范围旋转角度，达到最佳输出效果。
要英文的，不要机器翻译
不明白，为什么要英文的。我想帮你翻译，但是感觉一个一个字打上去，很累。貌似没见过在那里有复制的。
Work should pay attention to the cooling water temperature and flow rate. The maximum water temperature not higher than 35 ℃, maintained at below 25 ℃. Found when the water temperature is too high and with a break down in time for the cooling water. Minimum water temperature not lower than 0 ℃, 0 ℃ cooling water from the following please, not allowed to remain in the reservoir tube laser, or water ice, would result in the laser tube cracks. The flow of cooling water to ensure that the 2L-4L / minute so that a constant flow. If not give rise to laser cooling mode change control, leading to instability in output, decline in power.
Properly connected to the laser tube is negative. First of all, to correctly distinguish between the laser tube is negative, the output for the negative (-), the other end to the positive (+). If you want to connect welding electrode wire, please note that the temperature not too high, too lo