还有段要翻译的

六 热压
1、 1、按时上班，在规定时间内保质保量按时完生产任务
2、
3、 上班前必须检查机器是否正常，不准带故工作，检查炉板内有无垃圾杂物。对所压板子
4、
5、 的陈放时间（成品不能超过2小时，毛坯不能超过3小时）
6、
7、 上班时检查热压三要素是否达标（温度、时间、压力），并用手感每层热压板的温度是
8、
9、 否一致，否则不准上板，
10、 上板时要检验坯板是否达标（无重叠、闪缝不超过2MM、垃圾、缺边），不达标者
11、
12、 不准热压。
13、
14、 上板时要快、准、稳，防止干胶或撞坏板子

是:

6 hot
1, 1, work on time, in the quality and quantity within the specified time production tasks finished on time
2
3, the machine must be checked before work is normal, and therefore not allowed to bring the work to check whether the garbage junk inside the furnace board. Platen of the sub -
4
5, the landscapes of time (finished no more than 2 hours, rough not exceed 3 hours)
6
7, the three elements at work checking whether the compliance hot (temperature, time, pressure), and with the handle on each hot plate temperature is
8
9, no consistent, otherwise not allowed on the board,
10, the boards should be tested whether the compliance blanks (no duplication, no more than flash sewing 2MM, garbage, lack of edge), not compliance by
11
12, are not allowed to hot.
13
14, the boards should be fast, accurate and steady, to prevent the rubber gum, or crack up board

希望能取立我的答案如果正确.