示波器说明书?

来源：百度知道 编辑：UC知道 时间：2024/06/07 19:34:00
19.NORM/INVERT
Selects CHI operating in normal or inverted form,this combined with I+Ⅱ can operate add or subtract for input signals.
20.C.T.
C.T. is the abbreviation of component test,it is an application of oscilloscope for testing FET.Transistor.Diode,Zener,Inductor,Capacitor etc.which are in working or damaged.
On this oscilloscope the tested component is connected in component test jacks(5),press C.T.button,the trace on CRT oftested component should be displayed the characteristic trace of components are listed in appendix.
21.TIME/DIV
Has 20 steps which ranges are form 0.2 sec/div to 0.1us/div in1:2:5 sequence.
22.X-Y
Pressing the X-Y button apply the vertical signal to the CHI or Y input connector and the horizontal signal to the CHⅡ or X input connector and the positioning on the screen can been vertically controlled by CHI position control knob.
23.HOLD OFF
Provides controls of hold off time between sweep signals to
obta

太长了，加点分吧。
19.NORM/INVERT
Selects CHI operating in normal or inverted form,this combined with I+Ⅱ can operate add or subtract for input signals.
正常/倒置
选择通道I以正常形式还是倒置形式工作，这与I+II相结合可以对输入信号进行加或减的操作。
20.C.T.
C.T. is the abbreviation of component test,it is an application of oscilloscope for testing FET.Transistor.Diode,Zener,Inductor,Capacitor etc.which are in working or damaged.
On this oscilloscope the tested component is connected in component test jacks(5),press C.T.button,the trace on CRT oftested component should be displayed the characteristic trace of components are listed in appendix.
C.T.（元件测试）
C.T.是元件测试的缩写，这是将示波器用于测试场效应晶体管、三极管、二极管、齐那二极管、电感、电容等，它们可以是正在工作的，或者已损坏的。在本示波器上，被测元件被连接到元件的测试插孔（5），按下C.T.按钮，被测元件在阴极射线管上的径迹应该被显示。元件的特征径迹列于附录中。
21.TIME/DIV
Has 20 steps which ranges are form 0.2 sec/div to 0.1us/div in1:2:5 sequence.
时间/档
共有20个步级，范围从0.2s/档到0.1μs/档，以1:2:5的次序。
22.X-Y
Pressing the X-Y button apply the vert