高手翻译一下以下英文13,谢谢

来源:百度知道 编辑:UC知道 时间:2024/05/27 20:41:17
wave figure of the cutting force change. This single-chip
activates one interruption every 1 ms and the interruption
program continuously converts 8 values in 1 ms.
The 8 values are processed by polling for each conversion.
Polling is not subject to an efficiency problem here
because the conversion speed of the AD1674 is very fast,
requiring approximately 10 ms. To convert 10 values
takes only 100 ms with 900 ms left for data reading and
digital data filtering.
To reduce the effect of interference signals on the
sampling values and to increase the reliability of the
sampling data, the sampling values need to be processed
with a digitized filter. There are many types of filtering
methods, such as the limit speed filter and limit amplitude
filter used in the program determination method,
mean value filter, arithmetic average filter, sliding average
filter, etc. This research adopts the combined average
f

波图的切削力变化. 这个单片激活一个中断每1毫秒的中断程序不断皈依8值在1毫秒. 8价值观办理投票,为每个转换. 投票是不受一个效率问题,因为这里的转换速度的AD1674的非常快速, 大约需要10毫秒. 把价值10仅需100余900余留给数据读取和数字滤波. 减少了干扰信号的采样值,并增加可靠性的采样数据, 采样值必须加以处理,数字滤波器. 有许多种过滤方法, 如极限速度滤波和限幅滤波程序测定,均值滤波器 算术平均滤波,滑动平均滤波 等本研究采用了组合平均滤波法,能有效消除脉冲干扰. 最大和最小值连续采样N次被丢弃和算术平均数的计算是从 其余n )的2采样值. 这种方法可以滤除脉冲干扰以及小的随机干扰. 8 / D值分拣甩开极大,极小值的平均值,得到 避免干扰脉冲. 如果采样率= 1千赫和有1024个采样点, 它像采样1点,每1毫秒,总采样时间为1024•1毫秒= 1.024秒; 在每个采样点, 8点,是连续采样,在1毫秒(需要80镑) . 8价值观分拣甩开2顶部和底部2价值观 平均计算,从剩余价值4例(氮气+ N3型+ N4+三农五) / 4 . 事实上,总采样点, 1024•8点. 由于只有1值计算,每8个百分点, 共取样点1024个(只有1数据为例,每1毫秒) . 5.4切削力和传感器电路的应变计有限制的力量,它可以承受. 它用来作为传感装置,以避免损坏的传感器结构,当太 许多部队是应用在安装过程中,次 电子传感器光已被注册,以协助经营收紧传感器功能水平. 在正常情况下,当传感器安装到刀架,它