UC知道SOS 请求高手翻译英语
来源：百度知道 编辑：UC知道 时间：2024/05/28 16:41:13
The burr is an unavoidable annoying companion to metal
cutting. Burr is not only irritating hinder but also high cost
demanding hitch to remove afterward. In case of conventional
punching process, slug is pushed away by mechanical punch
and die. Fig. 1 shows a typical sheared section for a punching
or blanking process, which is consisted of roll-over, burnish,
fracture and burr [1,2].
In the slug obtained by conventional mechanical punching,
the cleaned burnish face is about one third of sheet thickness.
The remaining two thirds showa rough break and burr, which
require additional operations such as shaving, milling, reaming
or grinding. For the precise assembly, at least two, but
generally more, secondary operations are required. Thereby,
there have been lots of technology developments in order to
get fine blank or burr-less hole [3–5]. Clearance and sharpness
of the tools are critical factors of burr formation
cutting. Burr is not only irritating hinder but also high cost
demanding hitch to remove afterward. In case of conventional
punching process, slug is pushed away by mechanical punch
and die. Fig. 1 shows a typical sheared section for a punching
or blanking process, which is consisted of roll-over, burnish,
fracture and burr [1,2].
In the slug obtained by conventional mechanical punching,
the cleaned burnish face is about one third of sheet thickness.
The remaining two thirds showa rough break and burr, which
require additional operations such as shaving, milling, reaming
or grinding. For the precise assembly, at least two, but
generally more, secondary operations are required. Thereby,
there have been lots of technology developments in order to
get fine blank or burr-less hole [3–5]. Clearance and sharpness
of the tools are critical factors of burr formation
毛刺是不可避免的恼人的伴侣，以金属
切割。毛刺不仅是刺激性阻碍，而且成本高
要求顺利移除之后。在案件的常规
冲压过程中，塞，推走机械冲床
及模具。图。 1显示了一个典型的剪切第一个冲
或冲裁过程中，这是构成唱名，打磨，
骨折和毛刺[ 1,2 ] 。
在柱塞获得常规机械冲压，
清理打磨面对的是约有三分之一的板厚。
其余的三分之二昭和粗糙，打破和毛刺，
需要额外的操作，如剃，铣，铰孔
或磨削。为精确的大会，至少有两个，但
一般更多，中学和行动是必需的。从而，
有很多技术的发展，以
获得优良空白或毛刺少孔[ 3-5 ] 。清理和锐度
该工具的关键因素毛刺的形成。带有
适当的清理和尖锐的工具，我们可以缩小
毛刺，但毛刺免费冲压几乎是不可能的。主要
的目标，这项工作是开发一个新的冲压过程中
为了得到优良的空白/孔，最大限度地打磨面积andminimizing骨折领域的洞。
在这里，一个新的充液
冲压是提出了一个潜在的候选人
毛刺-免费冲压或穿孔的方法。
google
翻译
看得那是眼花缭乱