Cisco2950交换机密码问题

来源：百度知道 编辑：UC知道 时间：2024/05/23 18:14:25
我用的Cisco2950交换机的密码忘记了（包括特权模式、控制口、远程登录密码），怎么办？请高手指点。
soongun，英文我只能看个大概，能用中文吗？

Attach a terminal or PC with terminal emulation (for example, Hyper Terminal) to the console port of the switch. Use the following terminal settings:

9600 baud rate
No parity
8 data bits
1 stop bit
No flow control

Unplug the power cable.

Hold down the mode button located on the left side of the front panel, while reconnecting the power cord to the switch. You can release the mode button a second or two after the LED above port 1x is no longer illuminated.

The following instructions appear:

The system has been interrupted prior to initializing the flash file system.
The following commands will initialize the flash file system, and finish loading
the operating system software:

flash_init
load_helper
boot

Type flash_init.

Type load_helper.

Type dir flash:.
!--- Make sure to type a colon ":" after the dir flash
The switc