UC知道请帮我翻译以下安装说明书，急。。。翻译成英文
来源：百度知道 编辑：UC知道 时间：2024/05/24 17:03:29
第二步：安装图示先将圆弧压片穿上锣丝，然后将锣丝穿上脚管的孔对准层板锣母依次装上 （螺丝暂不要收太紧）
第三步：把其余层板按相同方法安装，装上后再均匀收紧螺栓
第四步：把可调脚和胶盖装上，安装完毕如图所示
第三步：把安装好胶脚的左右侧的脚管总成对准洗涮台面板下的管套插入，并用平头内六角螺丝稍微收紧。（需放在平整的地面进行安装，保持四脚平衡
第四步：把前后支撑管与左右两侧脚管用圆头内六角螺丝和圆弧压片连接稍微锁紧，然后通过调节把所有的螺栓和螺母锁紧使之洗刷台保持平衡
Step one: open the box remove the parts, check parts are complete
Step two: Install icon first arc pressed to put on gong wire, and then put on wire gong pin holes aligned laminate tube fitted with gongs followed by the mother (not to collect the temporary screws too tight)
The third step: the remaining laminate by the same method of installation, and then loaded on to tighten the bolts evenly
Step four: the adjustable legs and plastic lid fitted and installed as shown in Figure
The third step: to install rubber feet left and right side of the foot control panel assembly Alignment clean slate of Taiwan under the tube insertion, and use flat head screws Hexagon slightly tightened. (Need to be placed flat on the ground to install, maintain balance between legs
Step four: the front and rear support tubes and the right and left foot round tubes arc within the hexagon screws and locking tablet connection slightly, and then adjust all the bolts and locking nu