UC知道高分求模具英文翻译
来源：百度知道 编辑：UC知道 时间：2024/05/10 08:53:15
该无合模线纺纱管锭塑料注塑模具设计的关键是该模具必须带有斜抽芯装置，并要准确确定合模方向，且保证合模线不能在管子的外表面。出于用途考虑，它是用于缠绕棉纱，这就要求管子外表面足够光滑，本文就解决以上设计问题给予说明。并通过对塑件材料，质量 体积的分析与计算，合理选用注塑机，并对各个参数进行了校核，设计出一副合理，经济，适用的塑料注塑模具。
注塑模；斜抽芯；无合模线
No mold line of spindles spinning plastic mold design
The nil-ray tube spindles spinning plastic injection mold design, the key is to die with the ramp-pumping device and to accurately determine the direction of mold and mold guarantee Line is not in the external surface of the tubes. For purposes consider that it is used for winding yarn, which calls for the tubes outer surface smooth enough, This article solve design problems to provide an explanation. And pieces of plastic materials, the quality of analysis and volume calculation, a reasonable selection of injection molding machinery, as well as various parameters of the check, design a reasonable, affordable, suitable plastic injection mold.
Injection Mold; Pumped-ramp; No mold line
DO not match the mold line to spin cotton a tube a tablet a plastics molding tool a design
Should don't match the mold line to spin cotton a tube a tablet plastics to note the key of[with] the molding too