在线等高手帮忙翻译以下这段话,谢谢了,急!

来源:百度知道 编辑:UC知道 时间:2024/06/04 09:32:13
Moreover, One EOT crane with capacity of 10 ton is installed at the cast house for handling of mud, runner material and erection of equipment. Two manual mono-way trolleys with manual hoist shall work on the ring I beams, which is fixed on the bustle. Dust collecting unit shall work for dedusting of the tap hole and the outlet of the hot-metal ladle.
One 450 m3 blast furnace will be equipped with three top-fired pebble stoves. There are two tubular burners arranged on the dome and the blast temperature is then heated up to -1,150-1200 ℃ The stove is PLC controlled with the aim of dome temperature and waste gas temperature. In inetial stage, the dome temperature is lowered then the preset value, large flow rate of gas and air with reasonable fuel/air ratio is adopted for fast auto combustion. When the preset dome temperature is reached, then taking the dome temperature as target for auto control, i.e. keep the constant gas flow and enlarge the air flow. When the preset waste gas te

此外,一eot起重机的容量为10吨,是安装在铸造府为处理泥浆,转轮材料及园艺设备。两个手动单双向手推车与手动葫芦应工作,对响我横梁,这是一个固定的就更加热闹。集尘单位工作,应为除尘的水龙头孔和插座的热点-金属包。 <br>其中450 m3高炉将配备3顶燃卵石的火炉。有两个管状燃烧器安排在圆顶和热风温度,然后加热至-1,150-1200 ℃炉子是可编程控制器控制,其目的是穹顶温度和废气温度。在惯导阶段,穹顶温度降低,则预设值,大流量的气体和空气与合理的燃油/空气比,是采用快速自动燃烧。当预设的穹顶温度达到了,然后走穹顶温度为目标,为自动化控制,即保持恒定气体流量,并扩大内空气流通。当预设的废气温度达到了,那么opreating模式自动更改,让废气温度为目标,为自动化控制。 <br> 1.2.6.1粗煤气系统<br>最大天然气发电一高炉压力0.12 mpa的是约14万nm3 /小时。气体所产生的每一个高炉将推出经4高达需φ 1400毫米,然后连接到二日起来,并采取了来者不拒的φ 1700毫米,然后连接到一个下跌的后起之秀φ 2,000毫米( 4 -2-2-1配置) ,然后进入除尘器内直径9000毫米。 <br> <br>原油天然气之后的主要除尘将转达给袋式除尘器二次除尘。在常温下的气体是100 〜 280 ℃ 。之后,袋式除尘器粉尘含量的高炉煤气,应减少到5 〜 6 mg/m3 (高压下运作高炉) 。一个煤气柜可容纳5万m3 ,可安装供回收煤气。

分太少,介绍你去http://fy.iciba.com/