UC知道急求-帮我翻译一段专业文献
来源：百度知道 编辑：UC知道 时间：2024/06/02 12:53:56
1) 导轨接触：扇形段结构上，上下框架各有两个导轨架相互约束，以防止两个框架在水平方向的偏移，模型中将两个导轨架设置成水平方向的接触。
2) 球轴承-框架接触：上下框架通过等效杆相连。两个等效杆（加上对称后的两个，一共四个）通过四个球隔离块，铰接在上下框架上，完全支撑着上框架的重量，具体接触模型如下图1所示。油缸（铰链杆）、球隔离与上（下）框架之间的接触，采用的是刚体—弹性体的接触方式。中间的球隔离部分采用刚体接触形式，既可以加快整体模型仿真时候的收敛速度，又可以减少在接触时，球体接触部分的的应力波动与位置波动。
急！急！哪位大侠帮翻译一下吧，我水平太差了
Throughout the model, there are two main contact method: 1) Guide contact: segment structure, the top and bottom frame has two guides frame mutual, two frames in the horizontal direction of the offset in the model of the two guides frame set to horizontal orientation.2) ball bearings-frame contact: Framework equivalent rod.Two equivalent rod (plus two symmetric, after a total of four) approved four ball spacers, articulated in the top and bottom frame, fully supports the weight of the upper frame, specific contact model, as shown in Figure 1 below.Cylinder (hinge-bar), isolation and on contacts between the framework of a rigid body — the contact between the elastomers.The Middle ball isolation adopt rigid body contact form, you can speed up the integral model convergence rates of simulation time and will reduce in the contact, the contact section of the sphere stress fluctuation and fluctuation.